Bulkhead Van Storage Rack - Twin Shelf - 1200 mm Plywood

Revision C - 1180 mm overall height. Shelf floor heights remain 842 mm and 1138 mm; the left access opening remains 360 x 705 mm.

Keep everyday kit on hand while leaving a generous open bay below. This twin-shelf bulkhead rack combines full-width storage, a deeper lower tray and a shallower upper tray in natural plywood.

Two fixed shelves, useful space below

• Overall dimensions: 1200 mm wide x 470 mm deep x 1180 mm high.
• 12 mm natural plywood, unfinished, with visible layered edges.
• Two fixed shelves with 50 mm lower and 42 mm upper front and rear retaining lips.
• Clear shelf width: 1176 mm. Usable depth between lips: 422 mm lower / 252 mm upper.
• Shelf floor heights: 842 mm lower / 1138 mm upper.
• 830 mm beneath the lower shelf, with a low 60 mm rear support rail.
• Shaped end panels extend to the floor. The left panel has a floor-open access cutout, 360 mm wide x 705 mm high, with rounded upper corners. The back stays open.

Made for a straightforward build

Interlocking plywood tongues locate the shelves and lips in the end panels. Supplied flat pack with nine CNC-cut plywood panels, 66 x 3.5 x 30 mm assembly screws and an illustrated guide. Clamp the joints square and pre-drill with a 2 mm bit before fitting each screw.

Check your installation space

Check the dimensions and side profile against your van before ordering. This listing does not specify a particular vehicle model. Some trimming may be required to suit your van's ply lining and installation. Secure the rack to suitable structural mounting points before use; vehicle mounting fittings are separate. Secure stored equipment for travel.

This product is a storage rack positioned at a bulkhead, not a replacement vehicle partition. Tools and stored contents are not included. Images are renders of the cutting model; natural grain varies.

Downloads

Revision C illustrated assembly guide (PDF) · Revision C packing checklist (PDF)