GRID Glove Box Holder - Plywood Wall-Mounted Dispenser

Keep gloves close to hand with a tidy plywood dispenser. Load your carton from the top and pull gloves through the rounded front opening.

Your storage space

• Clear internal size: 250 W x 120 H x 70 D mm. Top loading, with a rounded front dispensing opening.
• Overall: 274 mm wide x 118 mm deep x 132 mm high.
• 12 mm natural plywood, unfinished, with exposed layered edges.
• Fixed slotted joints, supporting base and an open back beneath a narrow upper mounting rail.

The front opening is 180 x 60 mm. Check your carton fits with sliding clearance and its dispensing opening lines up with the frame. Load from above, facing forward. One holder accommodates one carton; gloves and cartons are separate.

Two-hole screw mounting

Two 4 mm through-holes in the upper rear rail, 180 mm centre to centre and 20 mm below the unit top, let you attach the unit to a suitable plywood or timber support. There are no hanging hooks. Fit the bare rail first for clear screwdriver access, then assemble the body around it.

Pair it with our plain plywood tool board, mounted securely with clearance behind it. The 3.5 x 30 mm mounting screws pass through the 12 mm rail and extend 18 mm into or through the support. Through a 12 mm board, allow approximately 6 mm behind it for the screw tips. The mounting board and its structural fixings are separate.

Supplied flat pack

Includes 5 CNC-cut panels, 14 assembly screws and two mounting screws, all 3.5 x 30 mm, plus an illustrated guide. Clamp joints square and pre-drill receiving edges with a 2 mm bit before fitting screws. Pre-drill the timber mounting support with a 2 mm bit too. Contents and tools are not included. Keep contents secured for travel.

Images are renders of the current cutting model; natural wood grain and colour vary.

Downloads

Revision B build and fitting guide (PDF) · Revision B packing checklist (PDF)